However, that wasn’t the look I was after. It would have been easier to just use regular and water proof butt connectors and electrical tape and it would have worked fine. I wanted to build a harness that was as close to OEM quality as I could reasonably get. Vetco Electronics Miscellaneous electrical supplies (Local to me)įry’s Electronics Miscellaneous electrical supplies (Local to me) Waytek Wire, connectors, terminals, relays, crimpers etc.īallanger Motorsports Connectors and terminalsĮastern Beaver OEM type terminals, connectors and crimpers.ĭigikey Electrical components of all types. Here are some of the places I used for the supplies and parts I needed:ĭIYAutoTune Pretty much all the major MS components and wiring. Once I started collecting the parts I spent a lot of time tracking down all the supplies I was going to need to build the harness and do the install in a way that I would be happy with. After a couple of months I realized that I had MS2 Extra firmware which has a whole other manual :doh: I read the Megamanual a number of times and planned out how I was going to do the install. Here is a list of Megasquirt and tuning resources that I used:Ī write up about installing Megasquirt on an X1/9 specifically. When I first began researching this project I started by reading a lot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |